C1382 Subaru Auto Trouble Code

C1382 Subaru OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

The crank but won't start condition, along with the trouble codes may make you think you've got a PATS anti-theft system problem. However, Ford reports that these codes are all related to software bugs. The only way around the problem is to reprogram the PCM with the latest software.

C1382 Subaru Possible Solution:

The firing order is an important part of the overall design of the engine and is determined during the design of the engine to eliminate as much engine vibration as possible. If the firing order is changed or adjusted, the ignition from the spark plug is delivered at the wrong time and the engine functions poorly or does not run. The firing order for a particular engine is typically found in the repair manual specific to that model.

C1382 Subaru Description For All Models :

Subaru 1.8
Subaru 1400
Subaru 1600
Subaru 360
Subaru Alfa
Subaru B11
Subaru B9
Subaru Baja
Subaru Coupe
Subaru Dl
Subaru Ff-1
Subaru Forester
Subaru Forester 1
Subaru Forester 2
Subaru Forester 3
Subaru G3x
Subaru G3x Justy
Subaru H6
Subaru Hm
Subaru Impreza
Subaru Impreza 2
Subaru Impreza 3
Subaru Justy
Subaru K111
Subaru Legacy
Subaru Legacy 3
Subaru Legacy 4
Subaru Leone
Subaru Liberty
Subaru M80
Subaru Mini Jumbo
Subaru Outback
Subaru Outback 2
Subaru Outback 3
Subaru Pleo
Subaru R1
Subaru R2
Subaru Rex
Subaru Sagres
Subaru Stella
Subaru Stx
Subaru Svx
Subaru Traviq
Subaru Tribeca
Subaru Vivio
Subaru Wx
Subaru Xt
Subaru Xv

C1382 Subaru Trouble Repair :

If your vehicle failed a C1382 Subaru test and the C1382 Subaru Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

Code Search

Please fill the search bar to find Auto Trouble Code meaning.

	Example: 0120